SMC Networks HRS Series - Page 119

DOC1001322
Chapter 5 Display and Setting of Various Functions
HRS Series 5.4 Description of the Screen
5-57
Table 5.4-24 Signal type for contact output signal 4 to 6
No. Indication Item Contact type Explanation
Normally open
Normally close
Operation：closed
Stop：closed
DIO mode：closed
DIO mode：open
the time of alarm：closed
the time of alarm：open
the time of alarm：closed
the time of alarm：open
the time of alarm：closed
the time of alarm：open
Maintenance reminders occurred：closed
Maintenance reminders occurred：open
TEMP READY status：closed
TEMP READY status：open
TEMP OUT status：closed
TEMP OUT status：open
10 EXTERNAL TEMP None － －
Enabled：closed
Enabled：open
Enabled：closed
Enabled：open
Enabled：closed
Enabled：open
Output the input signal as it is
Reverse output of the input signal
Output the input signal as it is
Reverse output of the input signal
Output the input signal as it is
Reverse output of the input signal
Selected alarm occurrence：closed
Selected alarm occurrence：open
Selected maintenance
reminders occurred：closed
Selected maintenance
reminders occurred：open
3
DIO Mode
DIO mode signal
4
Fault
Operation stop "FLT" alarm status
signal
1
Off
Disabling
2
Run
Operation status signal
7
Maintenance
Maintenance reminder status signal
8
TEMP READY
TEMP READY signal
5
Warning
Continuing operation "WRN" alarm
status signal
6
Alarm
Alarm status signal
ANTI-FREEZEING
Anti-freezing setting
status signal
13
WARMING UP
Warming up setting
status signal
9
TEMP OUT
TEMP OUT signal
11
START-UP
Startup setting
status signal
18
Select Maintenance
Maintenance remainders
status signal
About selectable maintenance remainders
Refer to "Table 5.4-26 List of maintenance reminders".
16
Mode Request Input
Mode request input signal(DIO)
(Pass through signal of the
contact input signal 3)
17
Select Alarm
Selected alarm status signal
Refer to "Table 5.4-25 List of alarm selection" for selectable alarms.
14
Digital Input 1
Pass through signal of the
contact input signal 1
15
Digital Input 2
Pass through signal of the
contact input signal 2
12