SMC Networks HRS Series - Refrigerant with GWP Reference; Communication Specifications

DOC1001322
Chapter 8 Documents
8.1 Specifications HRS Series
8-2
7 Required flow rate to maintain the cooling capacity. When the flow rate is lower than the rated flow, use a by-pass piping set.
8 Option D “With electrical conductivity control” only
 In the case of option M "Deionized water function", it is not included.
10 Only in the case of option M "Deionized water function", it is included
11 The anchor brackets (including M8 bolt x 6pcs.) are used for fixation with the skid when this product is packed. The anchor bolts are not attached.
12 The weight will increase by 14kg when option A "Caster-adjuster foot installed" is selected.
The weight will increase by 1kg when option D "With electrical conductivity control" is selected.
The weight will increase by 1kg when option K "Fluid fill port" is selected.
8.1.2 Refrigerant with GWP reference
Table 8.1-2 Refrigerant with GWP reference
Refrigerant
Global Warming Potential (GWP)
Regulation (EU) No 517/2014
(Based on the IPCC AR4)
Revised Fluorocarbons
Recovery and Destruction Law
（Japanese law）
R134a
1,430
1,430
R404A
3,922
3,920
R407C
1,774
1,770
R410A
2,088
2,090
Note:
1. This product is hermetically sealed and contains fluorinated greenhouse gases.
2. See specification table for refrigerant used in the product.
8.1.3 Communication specifications
 For contact input/output communications, refer to 3.3.4 Contact input/output
communication wiring