SMC Networks HRS Series - Installation

DOC1001322
Chapter 3 Transport and Setting Up
3.3 Installation HRS Series
3-8
3.3 Installation
3.3.1 Installation
 Use a bracket
1. Install this product according to the anchor bolts installed on the level floor.
2. Fasten the nuts to the anchor bolts.
3. Make sure that there is no looseness on any of the anchor bolts and nuts.
[Tips]
SMC Foundations bolt set “IDF-AB500” (SUS M10x50) is applicable. Please
order separately.
Fig. 3-4 Installation procedures
Install the product on a vibration free level floor.
Prepare the M10 anchor bolts suitable for the material of the floor that
the product will be installed on. Drive the anchor bolts in at least two
places on the product’s left and right sides (four places in total). Refer
to “8.2 Dimensions” for the position dimensions of the anchor bolts.
Bracket
H
o
l
e
f
o
r
a
n
c
h
Hole for anchor bolt (Φ12)
Base of the product
Nut
Anchor bolt
Hole for anchor
bolt (Φ12)
Floor
Nut