SMC Networks HRS Series - Operation Start and Stop; Setting of Circulating Fluid Temperature

DOC1001322
Chapter 4 Starting the Product
HRS Series 4.4 Operation Start and Stop
4-7
4. Repeat the procedures 1–3 until the fluid level of the product stops dropping.
[Tips]
While the low tank fluid level alarm (AL02) is still on (without turning off the
alarm), the home screen can be displayed to carry out independent pump
operation. If the fluid level continues to drop, the alarm “AL01 LOW level FLT”
is activated.
4.4 Operation Start and Stop
4.4.1 Setting of circulating fluid temperature
Press the [SP] value on the touch panel (home screen) to display numeric
keys to set the circulating fluid set temperature. Enter the set temperature.
Fig. 4-8 Setting of circulating fluid temperature
Touch this mark
Enter a value
Value shown in orange
Numeric keys