・Run/stop operation
21. Run/Stop the product. Press [ ] button when the product has stopped
running to display “Operation check screen”. Press [ ] button to start operation.
The [ ] button switches to the [ ] button as soon as operation starts.
Press [ ] button when the product is running to display “Stop check
screen”.Press [ ] button to stop the operation.
The [ ] button switches to the [ ] button as soon as operation stoped.
[Tips]
・If [ ] button is pressed when “Run/Stop (FLT)” alarm is activated,
the “Cannot Run” message appears.
Please turn off the alarm. Refer to “Chapter 6 Alarm Notifications and
Troubleshooting” for turning off the alarm.
・If the “Operation mode” is set to anything other than “LOCAL”, a “Switch to
the local mode” message appears. Set the running mode to the “LOCAL”
mode.
To Next Page
Loading...
