SMC Networks HRS Series - Fluid Supply Without Using the Automatic Fluid Fill Function

DOC1001322
Chapter 3 Transport and Setting Up
HRS Series 3.5 Circulating Fluid Supply
3-33
3.5.2 Fluid supply without using the automatic fluid fill function
To supply the circulating fluid without using automatic fluid fill function,
remove the upper panel on the right side, and supply the fluid to the fluid fill
port on top of the tank.
1. Remove the screws to remove the upper panel on the right side.
Fig. 3-19 Removal of the right side panel
2. Hold the handles and lift the upper right side panel, and remove it.
Remove the wing nuts (4 portions) on top of the tank and remove the lid also.
Fig. 3-20 Removal of the right side panel and the lid of the fluid fill port
Maintenance panel
Screws (6 portions)
Handles
Note: Pay attention not to lose
the wing nuts.
Wing nuts
Seal
Lid
fluid fill port