SMC Networks HRS Series - Contact Input;Output Communication Wiring

DOC1001322
Chapter 3 Transport and Setting Up
HRS Series 3.3 Installation
3-17
3.3.4 Contact input/output communication wiring
The product has a contact input/output communication function as shown
below. Connect cables referring to the applicable chapter for each function.
 Run/Stop input (Refer to “3.3 5 Wiring of the Run/Stop signal input”)
 Contact output signal
(Refer to “3.3.6 Wiring of the contact output signal”)
 Analog output signal (Refer to “3.3.7 Wiring of analog output signal”)
Use the signal cable described below for wiring of each function.
Contact Input / Output communication connector
The following connectors are used for this product as a contact input / output
signal connector. Please prepare suitable matching connector cable.
Table 3.3-2 Contact input/output communication connector
Connector specification (this product side)
D sub 25 pin female (socket) type
Fixing bolt:M2.6×0.45
Be sure to lock out and tag out the breaker of the facility power
supply (the user’s machine power supply) before wiring.
 Use the connectors specified.
 The capacity of the output contact of the product is limited. If the capacity is
not large enough, install a relay etc. (to allow for larger capacity). Also, ensure
that the input current of the relay is small enough in relation to the contact
capacity of the product.