SMC Networks HRS Series - Menu Key

DOC1001322
Chapter 5 Display and Setting of Various Functions
HRS Series 5.4 Description of the Screen
5-9
Table5.4-1 List of check items in inspection monitor menu
1 In the case of option D “With electrical conductivity control", to display the value.
No.
Item
Explanation
Referen
ce
page
(1)
Menu key
Touch the key to display the menu.
P.5-10
(2)
Date and time display
Displays the date and time.
Press the numeric section to set the date.
P.5-10
(3)
Current circulating fluid
temperature
Display circulating fluid temperature.
P.5-10
(4)
Operating condition
display
Displays TEMP READY status.
Displays the control status of the circulating fluid
temperature.
Displays the run and stop status of the product.
P.5-11
(5)
Compressor operating
condition display
Displays the run and stop status of the
compressor.
P.5-11
(6)
Pump Operating
condition display
Displays the run and stop status of the pump.
P.5-11
(7)
Tank fluid Level
Displays the tank liquid level in three levels:
"sufficient," "low," and "insufficient.
P.5-12
(8)
Circulating fluid
temperature
Displays the fluid flow rate. This value is not
measured by a flowmeter. It should be used as a
reference value (rough indication).
Displays the flow rate in the bypass circuit.
P.5-12
(9)
Circulating fluid
discharge pressure
Displays the discharge pressure.
P.5-12
(10)
Compressor circuit High
pressure side
Displays the High pressure side of refrigeration
circuit
P.5-12
(11)
Compressor circuit Low
pressure side
Displays the Low pressure side of refrigeration
circuit
P.5-13
(12)
Circulating fluid
electrical conductivity 
Displays the electrical conductivity.
P.5-13
(13)
Key lock condition
display
Displays the status of key lock settings.
P.5-13
(14)
Startup operation status
display
Displays the status of operation settings at
startup
P.5-14
(15)
Anti-freezing status
display
Displays the status of anti-freezing settings.
P.5-14
(16)
Warming up status
display
Displays the status of the warm-up settings.
P.5-14
(17)
Pump operation
continuation status
display
Displays the status of pump operation
continuation setting.
P.5-15
(18)
Circulating fluid set
temperature
Displays the set temperature.
Press the numeric section to change the set
temperature.
P.5-15
(19)
Operation mode
To select a operation mode from the touch
panel( mode), contact input ( mode)
or serial communication ( mode).
P.5-16
(20)
Independent pump
operation
Pump operates independently while the button is
pressed.
P.5-16
“Sufficient” “Low” “Insufficient”
Blue Yellow Red