・Operation mode MODE
19. Display the current run mode
Set the operation mode.
[ ]mode is set by default.
Operation mode can be selected from the following three modes:
・[ ] mode: The operation is performed by the touch panel.
・[ ]mode: The operation is performed by contact input signal.
(Refer to “5.4.9 Communication setting screen” for the setting of contact input signal）
・[ ] mode: The operation is performed by the serial communication RS-232C/RS-
485.(Refer to “5.4.9 Communication setting screen”. for Modbus/TCP communication.)
・Independent pump operation Pump
20. ［ ］Pump operates independently while the button is pressed.
To Next Page
Loading...
