DOC1001322
Chapter 7 Control, Inspection and Cleaning
7.2 Inspection and Cleaning
HRL Series
Removal of the dust-proof filter
1. The dust-proof filters are installed on the front and left sides of the product.
2. They can be removed as shown in the drawing below.
Care should be taken not to deform or scratch the air cooled condenser (fins) while
removing the filters.
Fig. 7-1 Removal of the dust-proof filter
Cleaning of dust-proof filter
Clean the dust-proof filters with a long bristled brush or by air blow.
Fig. 7-2 Cleaning of the dust-proof filter
To Next Page
Loading...
