SMC Networks HRS Series - Page 38

DOC1001322
Chapter 3 Transport and Setting Up
3.3 Installation HRS Series
3-22
2. Wire the contact input / output signal connector as follows and connect it to this
product. (This is a wiring example.)
Fig. 3-11 Wiring of Run/Stop signal input and remote signal input (Example)
14
〃
1
2
3
Pin No.
〃
〃
←Run/Stop signal
Inlet of the signal
cable
Note: Prepare a cable tie.
Fasten the signal cable to
the mount on the base with
the cable tie.
Mount for
cable tie
13
1
25
14
D sub 25 female pin (socket) type
Fixing bolt:M2.6×0.45