SMC Networks HRS Series - Page 56

DOC1001322
Chapter 4 Starting the Product
4.2 Preparation for Start HRS Series
4-4
Table 4.2-1 Items displayed on the home screen
No.
Classification
Item
Explanation
(1)
Displayed
value
Current circulating fluid
temperature
Displays the current temperature of circulating
fluid.
(2)
Operating condition display
It indicates the run and stop status of the
product.
(3)
Compressor
It indicates the run and stop status of the
compressor.
(4)
Pump
It indicates the run and stop status of the pump.
(5)
Tank fluid Level
Indicates the tank fluid level with three levels:
"Sufficient," "low," or "insufficient.
(6)
Circulating fluid flow rate
It indicates the fluid flow rate. This value is not
measured by a flowmeter. It should be used as a
reference value (rough indication).
(7)
Circulating fluid discharge
pressure
It indicates the discharge pressure
(8)
pressure gauge on high-
pressure side of compressor
circuit
Displays the pressure gauge on high-pressure
side of refrigerant circuit.
(9)
pressure gauge on low-
pressure side of compressor
circuit
Displays the pressure gauge on low-pressure
side of refrigerant circuit.
(10)
Circulating fluid electrical
conductivity 
It indicates the electrical conductivity.
(11)
Circulating fluid set
temperature
Displays the circulating fluid temperature
(12)
Button
Operation mode
To select a operation mode from the touch
panel( mode), contact input ( mode)
or serial communication ( mode).
(13)
Independent pump
operation
Pump operates independently while the button is
pressed.
(14)
Run/Stop
To run/stop the product.
1 In the case of option D "With electrical conductivity control", to display the value.
「Sufficient」 「low」 「insufficient.」
Blue Yellow Red