Smitec Cosmos 3152FA - Encoder 2 Input (E2) - Input Function

COSMOS DRIVER SERIES 3000 - USE AND MAINTENANCE MANUAL
5.3.7 Encoder input/output 2 (E2)
Depending on the models, the connector E2 can feature input signals for a second type of encoder or a repetition of the
signals connected to connector E1 (see chapter 3.2.2).
Connector type: D-SUB HD15 F (not supplied)
Order code: --------
Features Allowed conductor section
5.3.7.1 Encoder input
This input is used in mutual exclusion with encoder 1 input (E1); it is useful for the driver or for the process controlling
device in order to know the real position of the motor or of a mechanical component and take corrective actions, if
necessary. This input is mainly designed for Hyperface encoders.
Connector E2
Label Signal
1 +8Vdc
2 Sine +
3 Sine - (Rif.)
4 Cosine +
5 Cosine - (Rif.)
6
7
8
9
10
11 GND
12 Data +
13 Data -
14 NTC
15 NTC
SHELL Shield
Ver. 1.07 Pag. 42