SSwwiittcchh AAuuttoommaattiioonn
Pressing any automatable switch (Cut, EQ, Ins (insert), Cue and Fx1 to Fx4) will toggle its state and automatically
start writing data (the rec LED by the fader will light). The switches can be returned to Replay either by rolling back
or by pressing the Play button on the fader followed by the switch which is in Write. All channel switches can be
returned with a double-press of the Play button.
The states of these channel switches are stored separately from the fader data. Switch data is stored regardless of
the current fader status unless the switch has been put into Safe mode at the start of the Mix Pass. Whenever a
channel or group function is in Write, the fader’s rec LED will light.
Pressing the fader-based Match button, followed by an automatable switch, drops that switch into Write without
changing the current state of the switch. Match and Play are mutually exclusive. If one is active, selecting the
alternate function cancels the first one.
Using Match and Play to correct a switch
If you have pressed a switch in the wrong place, simply move the DAW to a position before the error, put the DAW
into Play, select Match and press the switch to automatically drop into Write without changing the stored state of
the switch at that point (see diagram below for the CUT switch). When the switch operation has been overwritten,
select Play and press the switch again to return to the previous automation state.
AAuuttoommaattiioonn
55--1166 DDuuaalliittyy SSEE OOppeerraattoorr’’ss MMaannuuaall
To Next Page
Loading...
Need help?
General
