DDAAWW CCoonnttrrooll
DDuuaalliittyy SSEE OOppeerraattoorr’’ss MMaannuuaall33--3366
Comparing Your Changes
Pressing the COMPARE button allows you to compare any changes made to plug-in parameters with the values
stored before editing. As soon as you change any parameter the COMPARE box will turn yellow. Pressing the
COMPARE button toggles between the settings when you starting editing parameters and the current settings.
Note that the plug-in window must be opened before this function becomes available
Bypassing Plug-ins
The BYPASS button allows a plug-In to be toggled in/out of the signal path in PARAM mode. In INSERT mode,
individual plug-ins can be bypassed by holding down the BYPASS button and pushing the D-pot that corresponds
to the insert you want to bypass. The channel SEL button can be used to bypass all the plug-ins on a channel.
D-pot Sensitivity
The Plug-in Editor’s D-pots can be set to one of two modes: Fixed or Velocity-sensitive. In Fixed mode,
turning a knob will range through the complete list of available parameters; this allows you to search through long
lists very quickly. Holding down the ALT button enables a finer resolution scroll function. In Velocity-sensitive
mode, the speed of scrolling is dependent upon how quickly you turn the D-pot. To toggle between the two modes
press the F5 button in the Fkys menu.
Note that the channel D-pots only operate in Fixed mode
To Next Page
Loading...
Need help?
General
