CCooppyy aanndd SSwwaapp
Copy and Swap (CS in the Auto menu) are used to interchange or transfer mix data between channels. The required
function is selected by pressing the CS soft key to toggle between the two modes.
Copy is displayed as Copy, Swap as Swap. Select the function required, hold down the source channel fader
button while you press the destination channel fader button. While the fader buttons are active, ‘src’ and ‘dest’
will be displayed in the scribble strip above each fader. Note that you can only Copy or Swap automation data when
the system is in Mix Running or Mix Review.
The Copy function copies data to a single channel only. To copy the same data to multiple channels, repeat the Copy
operation as many times as required.
The mix data generated by a Copy or Swap is not saved until the current Mix Pass is ‘Ended’.
FFaaddeerr LLiinnkkss
Fader Links are a useful method of ganging channels without the complexity of a Master/Slave style grouping system.
With a Fader Link, any fader or non-latching switch operation can be applied to all the channels in the link.
Faders retain any existing level offsets, provided no fader in the link reaches the upper or lower extremes of the
fader scale. If any member of a link reaches the end of its physical travel, no member of the link can move beyond
this point. To access Fader Links, press the Lnks soft key next to the Auto key..
While the CUT and SOLO switches are always included in Fader Linking along with the Fader, it is possible to
exclude the remaining automated channel switches from the Link: with a fader link highlighted in the Lnks page,
press the ChSws softkey. When switches are included in the Link, switches linked is displayed after the fader
link name on the screen (as shown for Link 2 above)
AAuuttoommaattiioonn
55--2200 DDuuaalliittyy SSEE OOppeerraattoorr’’ss MMaannuuaall
To Next Page
Loading...
Need help?
General
