DDAAWW CCoonnttrrooll
33--1111
Note: Logic’s Click and ports environment layer selects the SUM of all of the ipMIDI input ports as its default MCU
control data source. This may lead to difficulties when using multiple DAW layers. To avoid Logic responding to MIDI
messages intended for the other DAW layer, the Click and Port MIDI port mapping should be changed from SUM
to individual direct MIDI port assignment. The example below shows Logic on DAW layer 1:
Preferences/Control Surfaces Setup menu:
To enable DAW Automation, set the MMC midi port in File/Project Settings/Synchronisation/MIDI to ipMIDI port
14 (or Duality SE MIDI port 8 if you are using the console MIDI ports):
DDuuaalliittyy SSEE OOppeerraattoorr’’ss MMaannuuaall
To Next Page
Loading...
