Solo BETA - Gnd Pin; +5 V Pin

SOLO BETA User Manual



Figure 2 - Analogue Inputs and +5V External Supply
“GND” PIN:
This is the Ground or in another word the 0V reference of SOLO, so if you want to send an                   
analogue commands to SOLO, you need to make sure the Ground of the commanding unit (               
Arduino, Raspberry Pi , … ) is shared and connected with SOLO at this point.
“+5V” PIN: 
This is a 5V/1A output to supply external peripherals or controllers, remember that this output is               
fused, and if you drain more than 1A, the fuse will be blown ( internally ) and this output will                   
become dysfunctional for safety reasons.
 


www.solomotorcontrollers.com
January 2021 - Revision V_1.0.5 Copyright © 2020, All right Reversed. SOLO motor controllers.

14