SOLO BETA User Manual
Section 7 _ Micro USB 2:
This is the micro_USB 2 connector of SOLO which is used for upgrading the firmware as well as
sending and receiving digital packets and commands, in Commanding mode, this USB will be a
virtual COM port capable of putting SOLO into digital control mode and functioning in standalone
mode with only 1 USB cable and the Motor connected at the output. You can download the latest
drivers for this part from our website.
www.solomotorcontrollers.com
January 2021 - Revision V_1.0.5 Copyright © 2020, All right Reversed. SOLO motor controllers.
24
To Next Page
Loading...
