Solo BETA - Page 75

SOLO BETA User Manual


Now after this step you can start sending Position commands like below:

12- set the desired position to go at +2560 pulses (Quad pulses)  (Int32)
FF FF 00 1B 00 00 0A 00 00 FE

After a while when the Motor reached to the goal:

13- set the desired position to go at -45000 pulses (Quad pulses)  (Int32)

FF FF 00 1B FF FF 50 38 00 FE



www.solomotorcontrollers.com
January 2021 - Revision V_1.0.5 Copyright © 2020, All right Reversed. SOLO motor controllers.

75