Chapter 9: The Sonos® Controller 100
9-27
Line-In
From the Music menu, select Line-In Sources and press OK.
• To play music from this source, highlight it and press OK.
• To change the name of the component, highlight it and select Edit Name.
Choose a new name from the list, and press OK.
• To change the line-in level for this component, highlight it and select Edit Line
Level. Choose the line-in level appropriate for this device, and press OK.
A default (typical) line-in level is automatically assigned when you select a
source name. If the volume sounds too low, you can select a higher line level for
this device. You may experience clipping at higher volume levels if you set the
level too high.
To change the line-in encoding for these components, see "Line-In encoding" on
page 9-34.
Clock and Alarms
This section discusses how to use the clock and alarms features on a Sonos
Controller 100. For help using the Sonos Controller for Mac or PC, go to "Clock and
Alarms" on page 5-4. For help using the Sonos Controller 200, go to "Clock and
Alarms" on page 7-7.
Setting date and time
1. From the Music menu, select Clocks and Alarms.
2. Select Date and Time Settings.
3. Choose one of the following options:
• Select Time Zone. Use the scroll wheel to select your time zone from the list,
and then press OK. Next, select Date and use the scroll wheel to set today’s
date, pressing OK after each entry. If desired, you can change the date and
time display formats by selecting the corresponding options from the Date and
Time Settings menu.
•Or, select Select Date and Time from the Internet, and then press OK. Select
On or Off. When this is on, your Sonos system will periodically update the date
To Next Page
Loading...
