Chapter 2: System Setup
2-7
Step 2: Place ZonePlayers in the rooms of your choice
After connecting one Sonos component to your router, place other ZonePlayers in the
rooms of your choice.
If you are connecting a ZonePlayer 120
1. Attach speakers to a ZonePlayer 120:
• Your speaker’s power rating should be at least 75W for 8 Ohm speakers, and
at least 150W for 4 Ohm speakers. Do not connect speakers rated at less
than 4 Ohms.
• Use your thumb or finger to firmly push the spring-loaded speaker connector
post inward to reveal the connection hole.
• Insert the stripped end of the speaker wire into the hole, then release. The
stripped portion should be caught firmly in the connector post.
Note: Connect the red (+) and black (-) terminals from each speaker to the
corresponding terminals on the ZonePlayer. Mismatching of polarities will result
in weak central sound, and a distorted sense of sound direction.
When making connections, ensure that none of the strands of your speaker
wire come in contact with an adjoining terminal on the rear panel.
To Next Page
Loading...
