Chapter 9: The Sonos® Controller 100
9-35
3. Use the scroll wheel to select Uncompressed or Compressed encoding, and
press OK. When Compressed is selected, you will notice a slight delay before
the music starts to play. When Uncompressed is selected, this delay is
significantly reduced.
Selecting a different wireless channel
The Sonos Multi-Room Music System selects the optimal radio frequency channel
during setup. However, if you have other wireless devices using this channel, you
may want to switch the Sonos Multi-Room Music System to another channel to
avoid conflicts, as conflicts may cause audio drop-outs.
1. From the Music menu, select System Settings.
2. Select Advanced Settings>Wireless Channel.
3. Use the scroll wheel to select a different wireless channel, and press OK.
It may take several seconds for the switch to take effect. If you have music playing, a
short music dropout will occur during the wireless channel change.
1. From the Music menu, select System Settings>ZonePlayer Settings and press
OK. If you wish to change the name of a ZoneBridge, select ZoneBridge
Settings instead.
2. Use the scroll wheel to highlight the zone you wish to change, and press OK.
3. Select ZonePlayer Name, and press OK.
4. Choose one of the following options:
• Use the scroll wheel to select a new name from the list, and then press OK.
Or,
• Type a different name by selecting Enter New.
• Use the scroll wheel to select each letter, pressing OK after each entry.
•Press Accept to accept the new name, or press Cancel to leave the screen
without making a change.
To Next Page
Loading...
