Sonos Multi-Room Music System User Guide
A-2
Using your Sonos Controller for Mac or PC:
1. From the Music menu, select Set Up Music Library.
2. Select the music folder(s) stored on this computer, and click Remove.
3. Next, re-add the share by selecting Add a Share.
4. Select Add music stored on this computer and click Next.
5. Select the music folder you just removed, and click Next.
6. Click Finish.
Wired Sonos component not detected during setup
A network or firewall issue may be preventing the Sonos component that is
connected to your router from joining your Sonos system. You can try the steps below
to resolve this issue.
(If this is a wireless ZonePlayer, you can try moving the ZonePlayers closer together,
or wire the ZonePlayer temporarily to see if the problem is related to wireless
interference.)
If you are still experiencing problems, please contact the Sonos Customer Service
Center.
1. Check the firewall
Firewall software installed on the computer may be blocking the ports that Sonos
uses to operate. First disable all your firewalls and try to connect again. Click
"Firewall Information" on page 6-9(Macintosh) or "Firewall Information" on page 5-9
(PC) for help with this step. If this resolves the problem, you should configure your
firewall to work with the Sonos Sonos Controller for Mac or PC software. If this does
not resolve the problem, try step 2 below.
To Next Page
Loading...
