Chapter 2: System Setup
2-31
Ethernet switch connectors (2) Use Category 5 Ethernet cable to connect to a router,
computer, or additional network device such as a
network-attached storage (NAS) device.
LED indicators:
• Green (link connection)
• Flashing Yellow (network activity)
Right speaker terminals Use high-quality speaker wire to connect the right
speaker to the ZonePlayer.
Left speaker terminals Use high-quality speaker wire to connect the left
speaker to the ZonePlayer.
Voltage select AC 115/230 V
Select the voltage setting that is appropriate for your
country.
AC power (mains) input Use the supplied power cord to connect to power
outlet.
Analog audio in Use a standard RCA audio cable to connect the audio
outputs from a separate audio component such as a
CD player, to the ZonePlayer’s analog audio inputs.
Subwoofer output
Note: If you disconnect your
subwoofer, make sure to also
disconnect the subwoofer’s
cable from the ZonePlayer
output.
Connect a powered subwoofer to this output using a
standard RCA cable. The system will detect when a
cable is connected to the subwoofer output and adjust
the crossover frequency automatically.
To Next Page
Loading...
