SonoSite titan - Page 39

Chapter 2: Getting Started 33
Getting Started
To set up Display Information:
Figure 15 Setup Screen: Display Information
Patient Header
1 Press the Setup key.
2 Select Display Information.
3 Select the desired check boxes to display desired information in
the patient header.
Mode Data
1 Press the Setup key.
2 Select Display Information.
3 Select the desired check boxes to display imaging information
on the screen.
System Status
1 Press the Setup key.
2 Select Display Information.
3 Select the desired check boxes to display the system status on
the screen.
Reset
To return settings for this setup page to factory default, select Reset
from the on-screen menu.