Chapter 4: Measurements and Calculations 79
Meas. & Calcs
Gyn Calculation
1 Select Gyn exam type.
2 On a frozen 2D image, press the Calcs key.
3 Select Gyn.
4 Highlight the desired measurement from the calculations menu and
press the Select key.
5 Perform the measurement.
6 Select Save from the on-screen menu, or press the Enter key to save
the measurement to the patient report.
The saved measurement is shown at the bottom of the calculation
menu and a check mark is put in front of the measurement.
If desired, press the Save key to save the image with the
measurements displayed.
7 Highlight the next measurement and press the Select key.
8 Repeat these steps until all measurements have been performed.
View or Repeat
Saved
Measurement
1 Highlight the desired measurement from the calculations menu.
The saved measurement is shown at the bottom of the calculation
menu.
2 Press the Select key or the Caliper key to select the measurement.
3 Repeat the measurement.
The new results are displayed in the measurement and calculation
data area. You can compare the active measurement to the saved
measurement.
4 To save the new measurement, select Save from the on-screen menu,
or press the Enter key.
Note: This will save the new measurement to the patient report and
overwrite the previously saved measurement.
Delete
Measurement
1 Highlight the measurement.
2 Select Delete from the on-screen menu.
This will remove the last saved measurement from the patient report.
To Next Page
Loading...
