Sony CCD-TRV30 - Using a Car Battery; To Remove the Adaptor; To Remove the DC Pack

.I'
AC-V15/V16/V16A
1 2 3
WARNING
Power cord must only be changed at qualified service shop.
PRECAUTION
The unit is not disconnected from the AC power source as long as it is connected to the wall outlet,
even if the set itself has been turned off.
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
• If the POWER lamp does not light, set the selector to the center (AC-V26)/VTR (AC-V15/V16/
V16A) position and disconnect the power cord. After about one minute, reconnect the power cord
and set the selector to VTR (DC OUT) again.
To Remove the Adaptor
The adaptor is removed in the same way as the battery pack (p.9).
?_i_ii_i_!!_i_!i_ii!i_i!iliii!_i!!i_i__i_,ii'i_i!!_i_ii!iii!L_¸_ii_!!i_i_ii_ii'
Use the DCP-77 DC pack (not supplied). Connect the cord of the DC pack to the cigarette lighter socket
of a car (12 V or 24 V). Connect the DC pack to the battery mounting surface of the camcorder.
To Remove the DC Pack
The DC pack is removed in the same way as the battery pack. (p.9)
24