Preparing the Remote Commander
To use the Remote Commander, you must insert two size AA (R6) batteries. Use the supplied size AA
(R6) batteries.
(1) Remove the battery cover from the Remote Commander.
(2) Insert both of the size AA (R6) batteries with connect polarity.
(3) Put the battery cover back onto the Remote Commander.
2 3
J
Note on battery life
The battery for the Remote Commander last about 6 months under normal operation. When the
batteries become weak or dead, the Remote Commander does not work.
To avoid damage from possible battery leakage
Remove the batteries when you will not use the Remote Commander for a long time.
Using the Remote Commander
Make sure that the COMMANDER mode is set to ON in the menu system (p.33).
56
To Next Page
Loading...
