EasyManua.ls Logo

Sony CCD-TRV30 - On Handling Tapes; Camcorder Care; AC Power Adaptor

Sony CCD-TRV30
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
On Handling Tapes
Do not insert anything in the small holes on the rear of the cassette. These holes are used to sense the
type, thickness of tape, or if the tab is out or in.
Camcorder Care
* When the camcorder is not to be used for a long time, disconnect the power source and remove the
tape. Periodically turn on the power, operate the camera and player sections and play back a tape for
about 3 minutes.
* Clean the lens with a soft brush to remove dust. If there are fingerprints on the lens or LCD screen,
remove them with a soft cloth.
Clean the camcorder body with a soft dry cloth, or a soft cloth ligh'tly moistened with a mild
detergent solution. Do not use any type of solvent vchich may damage the finish.
AC Power Adaptor
Charging
Repeated charging while some capacity remains causes a lowering of battery capacity.
However, the original battery capacity can be recovered if you use the battery completely and
charge it fully again.
Charge the battery pack on a flat surface without vibration.
The battery pack will be hot during charging. This is normal.
Others
Unplug the unit from the wall outlet when not in use for a long time. To disconnect the cord, pull it
out by the plug. Never pull the cord itself.
Do not operate the unit with a damaged cord or if the unit has been dropped or damaged.
Do not bend the AC power cord forcibly, or put a heavy object on it. This will damage the cord and
may cause a fire or an electrical shock.
Be sure that nothing metallic comes into contact with the metal parts. If this happens, a short may
occur and the unit may be damaged.
Always keep the metal contacts clean.
Do not disassemble the unit.
Do not apply mechanical shock or drop the unit.
While the unit is in use, particularly during charging, keep it away from AM receivers and video
equipment because it will disturb AM reception and video operation.
The unit becomes warm while in use. This is normal.
Do not place the unit in locations that are:
- Extremely hot or cold
- Dusty or dirty
- Very humid
- Vibrating
If any difficulty should arise, unplug the unit and contact your nearest Sony dealer.
m,
¢D
o.
"U
c-
O
45

Table of Contents

Related product manuals