76
Setup Menu
12 DV1 PFKY
(DEVICE1 PROGRAMMABLE FUNCTION)
Sets the functions of the PF keys for the device 1.
[NO DEF]: Doesn’t set the assignable keys.
VTR DEF: 9-pin assignable setting for VTR.
MULT CUE: Enables the multi cue function.
13 DV2 PFKY
(DEVICE2 PROGRAMMABLE FUNCTION)
Sets the functions of the PF keys for the device 2.
[NO DEF]: Doesn’t set the assignable keys.
VTR DEF: 9-pin assignable setting for VTR.
MULT CUE: Enables the multi cue function.
14 BEEP
(BEEP SOUND)
Sets when to beep.
[OFF]: Doesn’t beep.
ALL: Beeps when the PF keys or ten-keys are pressed, when errors
occur, or when the IN or OUT point is played back during the
preview or the automatic editing.
ERROR: Beeps when errors occur.
15 SYSTEM
(SYSTEM FREQUENCY)
Sets the system frequency.
[29.97 FRM], 25 FRM, 24 FRM, 23.98 FRM
16 DIMMER
(VFD DIMMER)
Sets the brightness of the display.
100%, [70%], 45%, 20%
17 REF I/O
(REF I/O)
Selects whether to use the REF IN/OUT connector as an input
connector or an output connector.
[INPUT]: Uses as the input connector.
OUTPUT: Uses as the output connector.
Note
When the system frequency is set to 29.97 or 25 frames, the REF
IN/OUT connector cannot be used as an output connector.
18 SRC DIAL
(SEARCH DIAL)
Sets the way to enter the search mode.
[DIRECT]: Enters the search mode when the search dial is turned
except when recording or editing.
SRC KEY: Enters the search mode when the JOG/SHTL/VAR
button is pressed.
SRC KEY2: Enters the search mode when the JOG/SHTL/VAR
button is pressed. When you change the mode from the jog
mode to the variable or shuttle mode, the still state is
maintained until the outer ring of the search dial returns to the
center (still) position.
DIRECT2: Enters the search mode when the search dial is turned,
except when recording or editing. When you change the mode
from the jog mode to the variable or shuttle mode, the still state
is maintained until the outer ring of the search dial returns to the
center (still) position.
19 FNC MODE
(FUNCTION MODE)
Sets the function mode.
[NORMAL]: Remote control/editor mode
REPLAY: Remote control mode for DSR-DR1000A basic replay
XDCAM: Remote control mode for XDCAM/editor mode for XDCAM
20 RMT PARA
(REMOTE PARA RUN MODE)
Sets whether to control both the device 1 and the device 2
simultaneously.
[OFF]: Doesn’t control simultaneously.
ON: Controls simultaneously.
Item
number
Item name Settings
To Next Page
Loading...
