Sony STR-ZA2000ES - Page 31

STR-ZA1000ES/ZA2000ES/ZA3000ES
31
SPECIAL MODE
Various version displays of system, test, etc. can be performed.
Setting method:
1. Press the [
?/1
] button to turn on the main power.
2. While pressing the [DISPLAY] button, press the [A.F.D.], [MOVIE], [MULTI ST.] button in order, the message “SPECIAL MENU
ON” appears.
3. Press the [V] or [v] button, the message “<<< SPECIAL >>>” appears.
4. Press the [ENTER] button, the “SPECIAL MENU” is appears.
5. Each time the [V] or [v] buttons is pressed, the item is switched in the order of the following table.
Some items can change the content. Display the cursor by pressing the [b] button, and change the content by pressing the [V] or [v].
buttons, and fi x the content by pressing the [B] button when you want to change the content of the item.
Releasing method:
To release from this mode, while pressing the [DISPLAY] button, press the [A.F.D.], [MOVIE], [MULTI ST.] button in order again, the
message “SPECIAL MENU OFF” appears, and this mode is released.
Display of special mode:
Items Display Remark
Model setting (display) MODEL XX UCA XX: Model
System version SYSTEM VX.XXX X.XXX: System software version
Main version MAIN VX.XX X.XX: System controller software version
Video version VIDEO VX.XX X.XX: Video system controller software version
ADV version ADV VX.XX X.XX: Video processor software version
DSP SFLASH1 version DSP S.FLASH VX.XX X.XX: DSP serial fl ash software version
Network version NETWORK VX.XX XXXX: Network system controller software version
DSP debug mode menu <DSP DEBUG MENU> Not used for the servicing.
Line check for update LC FOR UPDATE >> When [b] button is pressed, the message “CHECK START ?”
is appears. When the [ENTER] button is pressed, the check of
whether the path used for software update has connected is
started.
When the checking results are OK, “UPDATE CHECK OK” is
appears.
When the checking results are NG, “UPDATE CHECK NG” is
appears.
HDCP key read mode HDCP KEY XXX Not used for the servicing.
MIC check SPK OUT XXXXXX
XXXXXX: Output setting from the speaker
SOURCE: normal mode
MIC: mode that output audio to the speaker from microphone
input
ARC check ARC CHECK XXX
XXX: “ON” or “OFF”
SPDIF signal reception on/off switched.
Zone A/D D/A check ZONE ADDA XXX Not used for the servicing.
Hub test mode HUB TEST XXXXX Not used for the servicing.
DCAC MIC TEST MODE
The auto calibration microphone input can be outputted from the
speaker.
Note: It is necessary to connect speakers to this unit.
Procedure:
1. While pressing the [OPTIONS] and [TONE MODE] buttons,
press the [
?/1
] button to turn on the main power.
2. The message “MIC” appears.
3. Check that sound which is inputted from microphone is out-
putted from the speaker.
Releasing method:
Press the [
?/1
] button to turn off the main power.
– Continued on next page –