Command Groups
VX4792 User Manual
3-17
The Output commands turn the output waveform on or off and select the position
on the waveform at which an external sync signal is generated.
Table 3-8: Output Commands
Header Description
%$
%$
%$
The Setup commands are used to set parameters for the clock, such as clock
source and frequency, and for the waveform output channel, such as the
waveform amplitude or cutoff frequency.
Table 3-9: Setup Commands
Header Description
$%
%!&
#
$
$"!
"#
Output Commands
Setup Commands
To Next Page
Loading...
