Sony Tektronix VX4792 - Table 3-7: Mode Commands

Command Groups
3-16
VX4792 User Manual
Table 3-6: Memory Commands (Cont.)
Header Description
!"%#   
!"%  $  %       $
!"%  $  %       $
!"%   
!"%          $
The Mode commands select the manner in which waveforms are output, such as
continuously or in bursts of a certain number of waveform cycles. These
commands also generate triggering events for waveforms and set trigger
parameters, such as impedance, level, polarity, and slope.
Table 3-7: Mode Commands
Header Description
  "!    
   $ "  "!   $  
#   "!    $   
!
  "!       %    
  "!
    !  !  #
"  $    & 
"         #
 
"$#     
"   !   #    
  !
"$#            
""#%   $  #    
 !
"     #    
 !
Mode Commands