Configuration and Installation
VX4792 User Manual
1-9
VX4792 Removal
The following procedure describes module removal from a Tektronix VXIbus
mainframe. If you are using a different mainframe, you may need to modify this
procedure.
1. On the mainframe, ensure that the power ON/STANDBY switch is set to
OFF.
2. Use a flat-bladed screwdriver to loosen the top and bottom retainer screws
(Figure 1–2).
3. Grasp both handles of the module. At the same time, move the top handle
upward and the bottom handle downward to eject the module.
4. Pull the module out of the mainframe.
To Next Page
Loading...
