VX4792 User Manual
1-3
Configuration and Installation
The Configuration and Installation section explains how to set the logical
address, prepare the VXIbus mainframe, and install the VX4792 Arbitrary
Waveform Generator into a mainframe. You must complete each of these tasks
before putting the waveform generator into service.
The VX4792 Arbitrary Waveform Generator requires two slots in a VXIbus
mainframe. This means that you can install up to six modules in a Tektronix
VX1410 C-size, 13 slot mainframe.
Within this section you will find instructions to perform the following tasks:
H Setting the Logical Address (page 1–4) explains how to set the logical
address for operation within your system. You must perform this task before
installing the waveform generator into a VXIbus mainframe.
H Preparing the VXIbus Mainframe (page 1–6) describes specifications and
configuration information you need to consider when selecting a VXIbus
mainframe for the waveform generator.
H VX4792 Installation (page 1–7) describes how to install the waveform
generator into a Tektronix VXIbus mainframe.
H VX4792 Removal (page 1–9) describes how to eject the waveform generator
from a Tektronix VXIbus mainframe.
To Next Page
Loading...
