Command Groups
3-18
VX4792 User Manual
The Status and Event commands are used by the external controller to set and
query the registers and queues of the VX4792 Arbitrary Waveform Generator
event and status reporting system. These commands let the external controller
coordinate operation between the waveform generator and other devices on the
bus. For the registers and queues described in Table 3–10, refer to the status and
event reporting system described in Status and Events.
Table 3-10: Status and Event Commands
Header Description
The Synchronization commands are used by the external controller to prevent
communication to the VX4792 Arbitrary Waveform Generator from interfering
with commands or other operations that the waveform generator is currently
executing.
Table 3-11: Synchronization Commands
Header Description
Status and Event
Commands
Synchronization
Commands
To Next Page
Loading...
