Sony Tektronix VX4792 - Table B-1: Normal Condition

VX4792 User Manual
B-1
Appendix B: Messages
Tables B–1 through B–8 list the status and event messages used in the status and
event reporting system. You use the  query to make the messages available
for dequeuing; you use the , , and  queries to dequeue and
return the messages. When using these queries, use the  query to make the
events available for return. The messages return as shown below:
H The  query returns the event code only.
H The , and  queries return both the event code and event
message in the following format:
<event code>, “<event message ; secondary message>”
Most messages returned have both an event message, followed by a semicolon
(;), and a second message which contains more detailed information. Although
these secondary messages are not listed in this manual, you can use the 
and  queries to display them.
Table B–1 lists the messages generated when the system has no events or status
to report. These messages have no associated SESR bit.
Table B-1: Normal Condition
Code Description
       
         
Table B–2 lists the error messages generated due to improper command
syntax. When these errors are encountered, check that the command is properly
formatted and that it follows the syntax.