Command Descriptions
3-44
VX4792 User Manual
<Manufacturer>, <Model>, <Serial Number>, <Firmware Level>
where
<Manufacturer>::=SONY/TEK,
<Model>::=VX4792,
<Serial Number>::=0,
<Firmware Level>::=CF:<Code and Format Version>,
<sp>FV:<Firmware Version>, and
<sp>::= Space.
*IDN?
might return SONY/TEK,VX4792,0,CF:91.1CT FV:1.0r1.0
*LRN?
The *LRN? common query returns all current settings for the waveform
generator. The settings returned are in the format of a sequence of commands. If
you save this query response, you can send it back later as a command sequence
to reestablish the saved settings.
SYSTEM
None
*LRN?
*LRN
?
None
Returns the settings as a sequence of commands, suitable for sending as set
commands later to restore a setup (see Examples below)
*LRN?
might return the following response:
:HEADER 1;:VERBOSE 1;:DIAG:SELECT ALL;:SELFCAL:SELECT ALL;
:MODE CONTINUOUS;:TRIGGER:IMPEDANCE HIGH;LEVEL 1.400;POLARITY
POSITIVE;SLOPE POSITIVE;INPUT INTERNAL;OUTPUT OFF;:WAVEFORM
"";:AMPLITUDE 1.000;:FILTER THRU;:OFFSET 0.000;:OPERATION
NORMAL;:CLOCK:FREQUENCY 1.000E+08;SOURCE INTERNAL;:OUTPUT:STATE
0;SYNC END;:DATA:DESTINATION "GPIB.WFM";ENCDG RPBINARY;SOURCE
"CH1"
Returns
Examples
Group
Related Commands
Syntax
Arguments
Returns
Examples
To Next Page
Loading...
