Command Descriptions
3-68
VX4792 User Manual
SELFcal:STATe
The command executes the calibration routine(s) selected with
the command. If an error is detected during execution, the
routine that detected the error stops immediately. If ALL (for all routines) is
selected with the command, self-calibration continues at the
next routine.
CALIBRATION and DIAGNOSTIC
SELFcal:SELect, SELFcal:RESult?
— performs calibration on selected routine
executes all calibration routines. After calibration is finished, the results are
returned.
Group
Related Commands
Syntax
Arguments
Examples
To Next Page
Loading...
