Sony Tektronix VX4792 - Page 200

VX4792 User Manual
C-1
Appendix C: Default Settings
Table C–1 lists the status of commands that are affected by power-up or the *RST
universal command.
Table C-1: Factory Initialized Settings
Command Group Header Default Settings
    DIAG:SELect ALL
    SELFcal:SELect ALL
  MODE CONTINUOUS
  TRIGger:IMPedance HIGH
  TRIGger:INPut INTERNAL
  TRIGger:LEVel 1.400
  TRIGger:OUTPut OFF
  TRIGger:POLarity POSITIVE
  TRIGger:SLOPe POSITIVE
  OUTPut:STATe 0
  OUTPut:SYNC END
  CLOCk:FREQuency 1.000E+08
  CLOCk:SOURce INTERNAL
  OPERation NORMAL
  AMPLitude 1.000
  FILTer THRU
  OFFSet 0.000
  WAVeform "
    DESE 256
    *ESE 0
    *SRE 0
  HEADer 1
  VERBose 1
  DATA:DESTination GPIB.WFM"
  DATA:ENCDG RPBINARY
  DATA:SOURce CH1"
  WFMPre:ENCDG BIN
  WFMPre:BN_FMT RP
  WFMPre:BYT_NR 2