Programming Examples
VX4792 User Manual
d. Set the output parameters as desired (see step 2 of the procedure on
page 2–40).
2. Setup the slave module.
. Always select the operating mode and clock source before loading a
waveform.
a. Set the slave module to operate in waveform advance mode (same as the
master module) with the following command:
b. Set the clock source to the local VXIbus with the following command:
c. Load a waveform file into the waveform memory with the following
command:
" !
The waveform generator settings will match the output parameters in the
waveform file.
d. Set the slave module to trigger from the same line as the master module
with the following command:
e. Set the output parameters as desired (see step 2 of the procedure on
page 2–40).
3. Activate the output at the WAVEFORM OUTPUT connector with the
following command:
4. Now the master module is waiting for a trigger signal. Apply a trigger signal
to the TRIGGER connector or enter the following command:
Both modules will output waveforms that are synchronized to the same
trigger.
To Next Page
Loading...
