Transportation/Setting-up
— 18 SPECTRO XEPOS — 19.01.2017
4 Transportation/Setting-up
Only instructed personnel may unpack, install, and set up the instrument.
Note! Measurement errors!
Shocks to the instrument during the measuring process may result in
measurement errors.
Therefore, shocks to the instrument when taking measurements must
be avoided.
Avoid mechanical impacts.
Measurement errors may result from temperature differences inside the
instrument.
Install the instrument so that it cannot heat up on one side only.
Observe the following information regarding the instrument's installation/transport:
Use the adjustable legs of the instrument in order to compensate for a slight
unevenness.
Always transport the instrument in a horizontal position, ensuring its legs are
pointing down.
Always keep the instrument upright when transporting it! To do this,use your
left and right hand to reach underneath the plastic housing. Remember that
the center point of gravity of in the front of the instrument.
Save the transport package in case you have to ship the instrument to the
service department at a later date.
All connections are located at the back panel.
When setting up the spectrometer, ensure all sides are easy to access
for maintenance and repair purposes, and electrical connections.
Set up the instrument to ensure the power isolators (switches and power
cable) can be easily reached.
All necessary cables and hoses are included in the delivery.
If the instrument is to be moved to another place of installation after set-up,
there is a risk of damaging the instrument. Contact the SPECTRO Service
Department in this matter.
To Next Page
Loading...
