Operation
SPECTRO XEPOS — 19.01.2017 — 29
Alternatively, if the start-up test fails based on a malfunction, the user will be
informed accordingly:
Note
If the start-up test fails, the safety circuits are faulty.
The high-voltage supply of the X-ray tube cannot be switched on.
In this case, please contact your Service Center.
5.3.3 Initialization of the stepping motors
During the initial isolation you will be prompted to remove the sample tray from the
sample chamber. If there is no sample tray inside the sample chamber, click on
"OK, Plate Removed".
Follow the instructions on the screen.
Details about the content and the progress of the initialization process can be seen
on the messages.
To Next Page
Loading...
