© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
Figure 42 Moving to ON in Remote Control
Note:
The QUBE Fiber Laser can be started using a serial protocol message, as long as Laser Start
is SET.
Laser ON can be asserted at any time to move the state to the ON state as long as the initial
state is in STANDBY state.
There is a small switching delay before Laser ON is acted on (<1ms) and Laser ON status is
SET or CLEARED
Figure 43 Moving to STANDBY in Remote Control
(No ramp down time configured)
To Next Page
Loading...