27
•
•
•
•
Do not remove the SIM unless instructed by your helpdesk. Unauthorised removal
of the SIM may render your terminal inoperable and/or may result in late/non-payment
of funds into your account.
Spire Payments reserves the right to charge for unauthorised use of your SIM. Spire
Payments may charge an administration fee for misuse or replacement of a lost or
locked SIM.
Your terminal will be pre-configured for use on standard networks featuring DHCP (automatic
allocation of IP addresses). In the unlikely event that your network does not have this feature,
please call the your helpdesk for assistance.
Please ensure the specific IP addresses and TCP ports provided by your terminal supplier
are not blocked by a network firewall.
The SPw70 portable terminal communicates through the mobile telephone network using a GPRS
connection. A Subscriber Identity Module (SIM) is pre-installed into the terminal by Spire Payments
to control this connection.
The following points should be noted:
The SPw60 is a portable device which utilises the wireless technology known as WiFi. This is ideal for
retail environments such as restaurants where waiters can take payment at the table. To install the
SPw60 you must note the following:
To operate the SPw60 within your premises you will also be provided with a WiFi access point. Both the
WiFi access point and terminal are pre-configured with all the necessary information to allow the
devices to communicate. Should the terminal or WiFi access point be replaced or the link between
the terminal and WiFi access point fail, reconfiguration may be needed. See Appendix F for details
of the SPw60 to WiFi access point pairing procedure.
Please note: If you are not using the Spire Payments provided WiFi access point then you may
have to configure your router to support the payment terminal, e.g. for MAC address filtering.
GPRS (SPw70 Portable Terminal Only)
WiFi (SPw60 Portable Terminal Only)
WiFi Access Point
Communications Information (Cont.)
Page 27.
To Next Page
Loading...
