Spire SPp10 - Training Mode

38
How To Switch To Training Mode
Using Training Mode
Once the terminal is switched to Training Mode it enables the user to perform all transaction types
without the actual transfer of funds. You may use normal Chip and PIN cards to perform these training
transactions.
PLEASE NOTE:
The Training Payment Card is not supplied with the terminal as standard.
Ensure the terminal is displaying the Welcome screen.
Once in Training Mode, the text ‘TRAINING MODE’ will be printed on all receipts. Depending on
the amount entered, the simulated response will be different, allowing staff to simulate all transaction
outcomes. Use the Training Payment Card to start a transaction.
Press the ‘MAIN MENU’ key to return to the Welcome screen.
If you are prompted for a cardholder PIN, use ‘1234’.
•
•
•
•
•
•
•
•
•
•
•
Press the ‘MAIN MENU’ key to display the Transaction Menu.
Select ‘TERMINAL’ from the menu.
Select ‘TRAINING’ from the menu.
Type in the local password (default is 0000) and press the green ‘ENTER’ key.
The screen will display ‘SWITCH TO TRAIN MODE’.
Select ‘YES’ by pressing the green ‘ENTER’ key.
0.01 to 100 (£0.01 to £1.00 or €0.01 to €1.00 in ROI) will display AUTH CODE XXXX.
200 (£2.00 or €2.00 in ROI) will display REJECTED.
300 (£3.00 or €3.00 in ROI) will display DECLINED BY CARD.
400 (£4.00 or €4.00 in ROI) will display PICK UP CARD.
Any other amount will display INVALID AMOUNT.
Training Mode
Page 38.