Spire SPp10 - Page 7

General Caution And Safety Instructions
How To Clean Your Terminal
Introduction
Safety Information And Battery Guarantee (Cont.)
•
•
•
•
•
•
•
•
•
•
•
•
Do not attempt to disassemble, service or repair any part.
Do not use if damaged or with signs of tampering.
Only use the supplied power adapter with electrical outlet of the correct rating.
To avoid the potential hazard of electrical shock do not use in wet environments or during
an electrical storm.
Do not use in the proximity of potentially flammable gases or substances.
Ensure cables used do not cause a trip hazard or risk the device being dropped on to a hard surface.
Do not expose to excessive heat or cold. Only operate between 0 °C and 40 °C.
Before cleaning disconnect from electrical outlet. Use only a dry or dampened soft cloth.
Do not immerse, use liquids, sprays or aerosol cleaners. Clean all spillages quickly.
This device is intended for handheld use only (SPw60 and SPw70 terminals).
Dispose any part in an environmentally sound manner and in accordance with local laws.
Spire Payments will not be held liable for any damage resulting from user operation that does
not comply with the guidance stated.
WARNING: DO NOT USE UNDILUTED AMMONIA OR ABRASIVE CLEANERS
Switch off and unplug the mains power supply units from the terminal, PIN Pad, charging stand and
WiFi access point where applicable. Carefully note how all the cables are connected and disconnect
all cables before cleaning.
Apply denatured alcohol (methylated spirits) to a clean, soft, non-abrasive, low-lint cloth. Carefully
wipe the entire terminal and WiFi access point.
Use an air duster (compressed air) to clean in and around the printer mechanism.