7.11.4 Interface
Figure 29. Camera module connector CN2
Table 42. Camera module MB1379 connector CN2
Pin number Description Pin connection Pin number Description Pin connection
1 TP2 NC 2 TP3 NC
3 GND GND 4 GND GND
5 NC NC 6 D11 PH15
7 GND GND 8 GND GND
9 NC NC 10 NC NC
11 GND GND 12 GND GND
13 I2C SCL PH4 14 I2C SDA PH5
15 PLUG MFX IO4 16 GND GND
17 RSTI MFX IO5 18 TP4 NC
19 XSDN MFX IO6 20 TP5 NC
21 GND GND 22 GND GND
23 D0 PC6 24 D1 PC7
25 D2 PG10 26 D3 PG11
27 D4 PE4 28 D5 PD3
29 D6 PB8 30 D7 PB9
31 HSYNC PA4 32 VSYNC PG9
33 PIXCLK PA6 34 TP6 NC
35 TP7 NC 36 TP8 NC
37 GND GND 38 GND GND
49 2V8 2V8 50 2V8 2V8
7.12
Wi-Fi
®
module MB1486
7.12.1 Description
An embedded serial to 802.11 a/b/g/n compliant Wi‑Fi
®
module, MB1486 with INVENTEK ISM43340-M4G-
L44-10CF, is connected to STM32H7B3LIH6QU SPI, I
2
C, and GPIO interface through U24.
7.12.2 Operating voltage
STM32H7B3LIH6QU Wi‑Fi
®
interface (SPI, GPIO, and I
2
C) can only be at 3.3 V on this board. A 5 V power
supply is required for the MB1486 Wi‑Fi
®
module with INVENTEK ISM43340-M4G-L44-10CF.
UM2662
Wi-Fi® module MB1486
UM2662 - Rev 1
page 45/95
To Next Page
Loading...
