QA BEAMCHECKER™ PLUS 2
General Precautions
Warnings and Cautions alert users to dangerous conditions that can occur if instructions in
the manual are not obeyed. Warnings are conditions that can cause injury to the operator,
while Cautions can cause damage to the equipment.
WARNING: Proper use of this device depends on careful reading of all instructions
and labels.
WARNING: Electrical shock hazard when connected to 300 V bias supply. Do not
disassemble the QA BeamChecker Plus.
WARNING: Where applicable, Standard Imaging products are designed to be used
with the versions of common radiation delivery devices, treatment planning
systems and other products or systems used in the delivery of ionizing radiation,
available at the time the Standard Imaging product is released. Standard Imaging
does not assume responsibility, liability and/or warrant against, problems with the
use, reliability, safety or effectiveness that arise due to the evolution, updates or
changes to these products or systems in the future. It is the responsibility of the
customer or user to determine if the Standard Imaging product can be properly
used with these products or systems.
CAUTION: This device should never be submerged in any liquid, scrubbed with an
abrasive cleaner, or be stored or placed where liquids could be spilled or splashed
onto it.
CAUTION: Do not drop, mishandle, or disassemble this device. Refer all servicing to
qualified individuals.
CAUTION: Do not irradiate this device past the 20 x 20 cm field label edge.
CAUTION: Always use the QA BeamChecker Plus in the same orientation during
Baseline Setup, Wire-Free, or Real-Time Operation Modes. Improper comparative
measurements and/or out of tolerance fault messages will occur if used in a
different orientation.
CAUTION: To help ensure measurement reproducibility over time and minimize
possible backscatter effects from the treatment couch, especially for low energy
photons, position the device in the same location on the treatment couch for every
measurement.
CAUTION: When using the Bluetooth® Adapter Kit, be careful lifting the unit when
it is lying flat to avoid damage to both the adapter and QA BeamChecker Plus. If
necessary, remove the adapter before moving the unit.
CAUTION: The Bluetooth Adapter Kit will not communicate through the treatment
vault wall, but because their signal is transmitted via RF, the cradle (with attached
adapter) can be placed inside a cabinet or closet and still communicate effectively.
CAUTION: When using TomoTherapy® or Dynamic 5 Channel modes, only the
photon side of the QA BeamChecker Plus should be used.
To Next Page
Loading...
Need help?
General
